Product Id: 22834890
Description: Perle CM-100MM-S1SC40U - Media converter - 100Mb LAN - 100Base-FX, 100Base-BX - SC multi-mode / SC single-mode - up to 40 km - 1310 nm / 1310 (TX) / 1550 (RX) nm
Mfr Part #: 05062170
Installed in a high density Perle media converter chassis, Perle's feature rich CM-100MM fast Ethernet fiber to fiber managed media converter module enables transparent fiber extension of 100Base-FX multimode fiber to 100Base-FX multimode or 100Base-LX/EX/ZX/BX single mode fiber.
Perle's advanced features make the end to end fiber link completely transparent. This allows for more efficient troubleshooting and less on-site maintenance. When used with a media converter management module in the chassis, configuration and monitoring of the fiber ports can be performed.
Whether you need to extend multimode to multimode or multimode to single mode, Perle has an extensive range of CM-100MM fast Ethernet fiber to fiber managed media converter modules to meet your fiber conversion requirement.
- 100Base-FX to 100Base-X fiber to fiber media converter module
- Multimode to multimode or multimode to single mode
- Extend multimode fiber to 120km (or more through chaining)
- Choice in SC, LC and ST fiber connector models
- Signal regeneration prevents signal degradation
- Advanced features: link pass-through, far-end fault, loopback for each fiber connection
- High density applications with Perle media converter chassis
- Manage via SNMP, Telnet/SSH, Internet browser with an MCR-MGT media converter management module
- Backup and restore
Provides fast and easy module replacement. Management module will always save a copy of the media converter configuration and will restore this configuration automatically to the media module when it is detected in the slot.
- Link pass-through
When enabled, the state of the receiver on one 100Base-X interface is reflected on the other 100Base-X fiber transmitter. If disabled, the 100Base-X fiber interfaces operate independently. Far-end fault indication on the 100Base-FX fiber interface has no effect on the other interface. Using link pass-through with far-end fault minimizes data loss when a fault occurs. If a fault occurs, the end devices have the indication of a failure available to making trouble shooting easier.
- Far-end fault (FEF)
When enabled, the media converter transmits the far-end fault indication over the fiber connection whenever a receive failure is detected. The media converter continuously monitors the fiber connection and clears the far-end fault indication condition when a valid signal is received. When disabled, far-end fault indications are not transmitted regardless of the condition of the receive signal on the 100Base-X fiber connection. The action the media converter takes on receiving a far-end fault indication is dependent on the Link Pass Through switch setting.
- Pause (IEEE 802.3xy)
Pause signaling is an IEEE feature that temporarily suspends data transmission between two devices in the event that one of the devices becomes overwhelmed. The media converter is transparent to pause frames.