Product Id: 22834812
Description: Perle S-100MM-S1SC20D - Media converter - 100Mb LAN - 100Base-FX, 100Base-BX - SC multi-mode / SC single-mode - up to 20 km - 1310 nm / 1550 (TX) / 1310 (RX) nm
Mfr Part #: 05060164
Perle's feature rich S-100MM Fast Ethernet Fiber to Fiber Media Converters enable transparent fiber extension of 100Base-FX multimode fiber to 100Base-FX multimode or 100Base-LX/EX/ZX/BX single mode fiber.
Perle's advanced features make the end to end fiber link completely transparent. This allows for more efficient troubleshooting and less on-site maintenance. In addition, a lifetime warranty and free worldwide technical support make Perle's S-100MM Fast Ethernet Fiber to Fiber Media Converters the smart choice for IT professionals.
Whether you need to extend multimode to multimode or multimode to single mode, Perle has an extensive range of S-100MM Fast Ethernet Fiber to Fiber Media Converters to meet your fiber conversion requirement.
- 100Base-FX to 100Base-X fiber to fiber media converters
- Multimode to multimode or multimode to single mode
- Extend multimode fiber to 120km (or more through chaining)
- Signal regeneration prevents signal degradation
- Advanced features: link pass-through, far-end fault, loopback for each fiber connection
- Link pass-through
When enabled, the state of the receiver on one 100Base-X interface is reflected on the other 100Base-X fiber transmitter. If disabled, the 100Base-X fiber interfaces operate independently. Far-End Fault indication on the 100Base-X fiber interface has no effect on the other interface. Using link pass-through with far-end fault minimizes data loss when a fault occurs. If a fault occurs, the end devices have the indication of a failure available to making trouble shooting easier.
- Far-end fault (FEF)
When enabled, the media converter transmits the far-end fault indication over the fiber connection whenever a receive failure is detected. The media converter continuously monitors the fiber connection and clears the far-end fault indication condition when a valid signal is received. When disabled, far-end fault indications are not transmitted regardless of the condition of the receive signal on the 100Base-X fiber connection. The action the media converter takes on receiving a far-end fault indication is dependent on the link pass-through switch setting.
- Signal regeneration
Signal regeneration maintains signal integrity and allows for maximum fiber to fiber connections without degradation.
Media converters can be cascaded. Two or more media converters can be chained in a link to achieve even greater distances.
- Pause (IEEE 802.3xy)
Pause signaling is an IEEE feature that temporarily suspends data transmission between two devices in the event that one of the devices becomes overwhelmed. The fast Ethernet media converter supports pause negotiation on the 100Base-TX copper connection.
The media converter is transparent to VLAN tagged packets.
- Remote loopback
The media converter can perform a loopback on each 100Base-X fiber interface.