Product Id: 22752869
Description: Perle CM-1110-S1SC80U - Fiber media converter - GigE - 10Base-T, 100Base-TX, 1000Base-T, 1000Base-BX-U - RJ-45 / SC single-mode - up to 80 km - 1510 (TX) / 1590 (RX) nm
Mfr Part #: 05052970
Installed in a high density Perle media converter chassis, Perle's line of feature rich managed 10/100/1000 rate converting media converter transparently connects copper to fiber. The 10/100/1000 Ethernet to fiber converter provides an economical path to extend the distance of an existing network, the life of non-fiber based equipment, or the distance between two devices.
Network administrators can "see-everything" with Perle's features such as auto-negotiation, auto-MDIX, link pass-through, fiber fault alert, and loopback. Along with a media converter management module in the chassis, configuration and monitoring of the copper and fiber ports can be performed. These cost and time saving features make Perle's Managed 10/100/1000 media converter module the smart choice for IT professionals.
- 10/100/1000 Base-T to 1000Base-X fiber media converter
- Connect 10/100 devices to gigabit backbone
- Smart link pass-through, fiber fault alert, auto-MDIX and loopback
- High density applications with Perle media converter chassis
- Manage via SNMP, Telnet/SSH, Internet browser with an MCR-MGT media converter management module
Auto-MDIX (automatic medium-dependant interface crossover) detects the signaling on the copper Ethernet interface to determine the type of cable connected and automatically configures the connection when enabled. The media converter can also correct for wires swapped within a pair. The media converter will adjust for up to 120 ns of delay skew between the 1000Base-T pairs.
- Backup and restore
Provides fast and easy module replacement. Management module will always save a copy of the media converter configuration and will restore this configuration automatically to the media module when it is detected in the slot
- Auto-negotiation (802.3u)
The media converter supports auto negotiation. The 1000Base-X fiber interface negotiates according to 802.3 clause 37. The 10/100/1000Base-T negotiates according to 802.3 clause 28 and 40. The 1000Base-X will link up with its partner after the highest common denominator (HCD) is reached and the copper has linked up with its partner. The 1000Base-X will continue to cycle through negotiation transmitting a remote fault of offline until the copper is linked up and the HCDs match.
- Smart link pass-through
When the link mode switch is placed into smart link pass-through mode, the copper Ethernet port will reflect the state of the 1000Base-X media converter port. This feature can be used whether fiber auto-negotiation is enabled or disabled.
- Fiber fault alert
With fiber fault alert the state of the 1000Base-X receiver is passed to the 1000Base-X transmitter. This provides fault notification to the partner device attached to the 1000Base-X interface of the media converter. If the 1000Base-X transmitter is off as a result of this fault it will be turned on periodically to allow the condition to clear should the partner device on the 1000Base-X be using a similar technique. This eliminates the possibility of lockouts that occur with some media converters.
- Pause (IEEE 802.3xy)
Pause signaling is an IEEE feature that temporarily suspends data transmission between two devices in the event that one of the devices becomes overwhelmed. The media converter supports pause negotiation on the 10/100/1000Base-T connection and 1000Base-X fiber connection.